Skip to main content

Multi-functional power supply with built-in voltage, current, and frequency meters

While prototyping your new project, you might want to know how much power your designed circuit will draw from the source voltage. One way to find it is to connect an ammeter in series with the circuit and determine the current drawn from the source. Then, knowing the source voltage you can easily determine the power. But doing this may not be always convenient. This project describes a special power supply unit that has built-in features for measuring the source voltage and current. Therefore, you can monitor both the parameters continuously while experimenting your circuit.




Check the details of the project HERE.
Labels:

Comments

  1. AnonymousMarch 17, 2019 at 9:21 AM

    Thanks for another wonderful post. Where else could anybody get that type of info in such an ideal way of writing? 54y8886

    ReplyDelete

Post a Comment

Popular posts from this blog

Contact less tachometer using PIC16F628A

Introduction Tachometer is a device that gives you the information about the rotational speed of any shaft or disc. It usually measures the speed in revolutions per minute (RPM). Today we are going to make a simple tachometer that could measure the rotation speed of a disk without making any physical contact (that's why it is contact less) with the rotating object. The range of this tachometer is 0 - 9999 RPM and displays the RPM on a multiplexed 4-digit seven-segment display. Of course, we are going to do this project on our usual PIC16F628A development board. Infrared sensor Contact-less measurement of RPM will be achieved through an IR sensor. An IR diode will send a beam of infrared towards the rotating disc, and any reflected pulse will be received by a photo diode. The resistance of a photo diode drops drastically when exposed to infrared. An infrared is reflected by a white surface and absorbed by the dark ones. The test disc for this project is shown below. You can see ...
32 comments
Read More

PIC16F628A Development Board

The development board we are going to make for our experimental microcontroller PIC16F628A will look like this. Here are the features it is going to have: Access to all I/O pins through female header pins 4 Push Buttons for Input 4 LEDs for Output An LCD Interface Port A 4-digit Seven-Segment Display Interface LCD Backlight Switch and Contrast Adjustment ICSP Programming (Very Important)
14 comments
Read More

Experiment No. 3: LCD Interface in 4-bit Mode

The objective of this experiment is to interface a 16x2 LCD to PIC16F628A in 4-bit mode. This means the data transfer will use only four pins of the microcontroller. There is no additional hardware setup needed for this experiment, as we have a ready-made LCD interface female header. We only need to define the data transfer and control pins in the software. Remember, the LCD interface in our development board uses the following pins of PIC16F628A: Data Transfer : D4 -> RB4, D5 -> RB5, D6 -> RB6, D7 -> RB7 RS -> RA0, and EN -> RA1
24 comments
Read More