Skip to main content

Posts

Showing posts with the label mikroC

PIC16F688 based Digital Voltmeter

Actually this is the another version of my older DVM project that was based on PIC12F683. The older version displays the measured voltage on a LCD that is driven serially by PIC12F683 using 3 I/O pins. The new one uses PIC16F688 microcontroller that doesn't require the serial driver as it has got enough pins to drive a LCD directly in 4-bit mode. The theory and math is just the same. You can read my PIC12F683 version of this project here . Circuit Diagram Circuit on breadboard

Digital Voltmeter using PIC12F683

This is a digital voltmeter project based on PIC12F683 microcontroller. It measures and displays input voltage from 0 to 20V with high accuracy. You cannot feed 20V directly to PIC port, so a simple resistor divider network is used for this purpose. A 5.1V zener diode is used to prevent any damage to PIC port in case the input voltage goes way above 20V. Since PIC12F683 does not have sufficient pins to drive a LCD, 3-wire serial discussed before is used to display the measured voltage.

PIC16F628A + DS1820 + 4-Digit Seven Segment C/F Thermometer

Introduction This project describes how to read temperature from a DS1820 sensor with a PIC16F628A microcontroller and display the temperature value in a multiplexed 4-digit seven segment display. The temperature will be displayed in both Centigrade and Fahrenheit units switching back and forth. The temperature resolution is 1 degree in both the units. Out of 4-digits, the most significant three digits will display numeric temperature values from 00 to 125. The most significant digit will show '-' for negative temperatures, and the least significant digit will display C or F. On my PIC16F628A board, connect D1 to RA2, D2 to RA1, D3 to RA0, and D4 to RA3. DS1820 data will be read at RA4 port. The seven segments a-g will be driven by RB0-RB6. Software /* Project name:      Seven-segment display digital thermometer  * Copyright:      (c) Rajendra Bhatt, 2010.       MCU:             PIC...

Using ADC in mikroC

With mikroC built-in library, use of ADC on PIC microcontrollers has become more simple. PIC16F628A doesn't have in-built ADC in it, so I am going to demonstrate this with my PIC12F683 development board. The analog input will be given through a potentiometer, and the 10-bit digital output will be displayed on a hyperterminal window on PC.