Skip to main content

Multi-functional power supply with built-in voltage, current, and frequency meters

While prototyping your new project, you might want to know how much power your designed circuit will draw from the source voltage. One way to find it is to connect an ammeter in series with the circuit and determine the current drawn from the source. Then, knowing the source voltage you can easily determine the power. But doing this may not be always convenient. This project describes a special power supply unit that has built-in features for measuring the source voltage and current. Therefore, you can monitor both the parameters continuously while experimenting your circuit.




Check the details of the project HERE.
Labels:

Comments

  1. AnonymousMarch 17, 2019 at 9:21 AM

    Thanks for another wonderful post. Where else could anybody get that type of info in such an ideal way of writing? 54y8886

    ReplyDelete

Post a Comment

Popular posts from this blog

Experiment No. 3: LCD Interface in 4-bit Mode

The objective of this experiment is to interface a 16x2 LCD to PIC16F628A in 4-bit mode. This means the data transfer will use only four pins of the microcontroller. There is no additional hardware setup needed for this experiment, as we have a ready-made LCD interface female header. We only need to define the data transfer and control pins in the software. Remember, the LCD interface in our development board uses the following pins of PIC16F628A: Data Transfer : D4 -> RB4, D5 -> RB5, D6 -> RB6, D7 -> RB7 RS -> RA0, and EN -> RA1
25 comments
Read More

Contact less tachometer using PIC16F628A

Introduction Tachometer is a device that gives you the information about the rotational speed of any shaft or disc. It usually measures the speed in revolutions per minute (RPM). Today we are going to make a simple tachometer that could measure the rotation speed of a disk without making any physical contact (that's why it is contact less) with the rotating object. The range of this tachometer is 0 - 9999 RPM and displays the RPM on a multiplexed 4-digit seven-segment display. Of course, we are going to do this project on our usual PIC16F628A development board. Infrared sensor Contact-less measurement of RPM will be achieved through an IR sensor. An IR diode will send a beam of infrared towards the rotating disc, and any reflected pulse will be received by a photo diode. The resistance of a photo diode drops drastically when exposed to infrared. An infrared is reflected by a white surface and absorbed by the dark ones. The test disc for this project is shown below. You can see ...
32 comments
Read More

Experiment No. 5: Multiplexed Seven Segment Displays

In this experiment, we are going to learn how to interface more than one 7-segment LED display to a PIC Port using multiplexing technique. We are going to interface a 4-digit common cathode seven segment display to our PIC board. The multiplexing circuit is already built up in the board using 4 transistors and few resistors (Read Make Your Own PIC Development Board ). The basic idea of multiplexing is that all seven segment displays are connected to the microcontroller in parallel and the microcontroller alternately prints ones, tens, hundreds, and thousands digits, selecting one at a time. The switching among the digits is so fast that it gives an impression of simultaneous light emission. Experimental Setup: 1. Connect RA0 through RA3 to 7-Segment Digit Select headers DG1, DG2, DG3, and DG4 using jumper wires. 2. Insert 7FR5641AS 4-Digit Seven Segment module in to its place on the board.
9 comments
Read More